Use the I-Wedge Tool to install I-Pins, Eye-Wedge Anchors and Powers' Tie-Wire Spike Anchors using the "hammer only" feature of an SDS Plus hammer drill.
Attaches to any SDS Plus Hammer Drill
Weighs .40 lbs.
Proposition 65 Warning for California Residents
Required tools and fasteners: ODM, ODM-250, ODM I-Wedge, ODM-IP
Step 1. Drill a 1/4" hole in the concrete ceiling using an ODM (Overhead Drill Machine) and an ODM-250 1/4" x 1.25" HALT BIT.
Step 2. Remove the ODM-250 HALT bit and insert an ODM I-Wedge SDS Plus installation tool into your hammer drill, set the hammer drill to hammer only.
Step 3. Insert a pre-tied ODM-IP 1/4" I-Pin anchor into the slot of the ODM I-Wedge installation tool and hammer the anchor into the hole.
Step 4. Pull down to set the anchor.
Website by Excel Web Design; J-Hooks