The ODM G2 is the ultimate all-in-one extension tool for overhead drilling applications. The universal saddle fits most "D" handle rotary hammer drills on the market. The ODM G2 is the most efficient and effective tool of its kind. Use it to install anchor wedges, eye pins, eye wedge anchors as well as a variety of other anchors safely from the ground. The ODM G2 Telescoping Overhead Drill Machine can be used for Concrete Ceilings up to 13'.
See below videos for use of the ODM G2 Pole Tool
Proposition 65 Warning for California Residents
Required tools and fasteners: ODM, ODM375, ODM916, TE-12, Torque Wrench, 3/8" Wedge Anchor, HOCL-45 Angle Clip, ceiling wire.
Step 1. Drill a 3/8" hole into the concrete ceiling using an
ODM (Overhead Drill Machine) fitted with an ODM375 3/8"x 3.325" HALT bit.
Step 2. Remove the
ODM375 HALT bit and insert an ODM916 SDS Plus 9/16" socket adapter, set the hammer drill to hammer only.
Step 3. Insert a 3/8" wedge anchor with a
HOCL-45 angle clip prettied to ceiling wire into the ODM916 socket adapter.
Step 4. Raise the
ODM up to the hole and insert the wedge anchor using the hammer function of the hammer drill.
Step 5. Use a
TE-12 extension pole equipped with a LMP 9/16 Hex Plug to tighten the 9/16" nut on the wedge anchor to the appropriate torque using a torque wrench (Usually 25 ft/lbs).
Required tools and fasteners: ODM, ODM-250, ODM I-Wedge, ODM-IP
Step 1. Drill a 1/4" hole in the concrete ceiling using an
ODM (Overhead Drill Machine) and an ODM-250 1/4" x 1.25" HALT BIT.
Step 2. Remove the
ODM-250 HALT bit and insert an ODM I-Wedge SDS Plus installation tool into your hammer drill, set the hammer drill to hammer only.
Step 3. Insert a pre-tied
ODM-IP 1/4" I-Pin anchor into the slot of the ODM I-Wedge installation tool and hammer the anchor into the hole.
Step 4. Pull down to set the anchor.
Website by Excel Web Design; J-Hooks